Easylase USB Controller

Post by **cyplex** » Wed 22 Mar, 2006 4:39 pm

Hello,

i have a easylase usb controller but the device has no dmx connectors or tll connector in the case

Does some one have a easylase usb controller with those connectors? if so is it possible to make some pictures of it so i can build the connectors on in

thanks..

Post by tl » Wed 22 Mar, 2006 7:42 pm

Download the .zip file with the documentation and drivers here

Inside the .zip is the schematic for the DMX part...

Hope this helps...

Post by **cyplex** » Wed 22 Mar, 2006 9:48 pm

thank you, now i know the layout the only problem left is that i don't understand the 2 symbols (max485cpa) are those ic's ? or is it possible to connect those dmx connectors directly to the board?

Post by **jojo** » Thu 23 Mar, 2006 9:41 am

cyplex wrote:thank you, now i know the layout the only problem left is that i don't understand the 2 symbols (max485cpa) are those ic's ? or is it possible to connect those dmx connectors directly to the board?

These are ICs.
But I think you should buy the addon-board or let somebody else build the addon board for you

If you don't know exactly how to do, you can damage the whole thing.

Joachim

Post by **genesis** » Thu 23 Mar, 2006 10:29 am

yes i think this is the better solution if you not know the electronic

the max485 are RS485 bipolar drivers/receivers

Post by **doctoritchy** » Thu 23 Mar, 2006 11:08 am

the IC create symetrical signal for DMX standrat and preamplifer for long distançe

Post by **cyplex** » Thu 23 Mar, 2006 4:18 pm

well now do know what the symbols are now i could build it normaly i don't build electronics on this way i use always a diverent layout and symbols.

Does any one have a id what the add on board cost?

i live in the netherlands.

www.LaserFreak.net

Easylase USB Controller

Easylase USB Controller

Who is online