Easylase USB Controller

[cyplex]

Hello,

i have a easylase usb controller but the device has no dmx connectors or tll connector in the case

Does some one have a easylase usb controller with those connectors? if so is it possible to make some pictures of it so i can build the connectors on in

thanks..

[tl]

Download the .zip file with the documentation and drivers here

Inside the .zip is the schematic for the DMX part...

Hope this helps...

[cyplex]

thank you, now i know the layout the only problem left is that i don't understand the 2 symbols (max485cpa) are those ic's ? or is it possible to connect those dmx connectors directly to the board?

[jojo]

thank you, now i know the layout the only problem left is that i don't understand the 2 symbols (max485cpa) are those ic's ? or is it possible to connect those dmx connectors directly to the board?

These are ICs.
But I think you should buy the addon-board or let somebody else build the addon board for you
If you don't know exactly how to do, you can damage the whole thing.

Joachim

[genesis]

yes i think this is the better solution if you not know the electronic
the max485 are RS485 bipolar drivers/receivers

[doctoritchy]

the IC create symetrical signal for DMX standrat and preamplifer for long distançe

[cyplex]

well now do know what the symbols are now i could build it normaly i don't build electronics on this way i use always a diverent layout and symbols.

Does any one have a id what the add on board cost?

i live in the netherlands.