Phoenix Micronet slim + switch rj45 trouble

Fragen und Antworten zur Installation

Moderators: m.phoenix, c.phoenix

Post Reply
philippe69
Posts: 483
Joined: Sun 20 Jan, 2013 5:15 am
Do you already have Laser-Equipment?: 1 laser 2w 532 nm
Scanner 40 kpps

1 laser Aworldlaser 6w rgb Scanner pangolin 506

4 laser Aworldlaser RGB 10w scanner DT40 60 degrés

1 laser Aworldlaser 14w rgb Scanner DT40 60 degrés
Red 637 blue 465 green 520

1 laser Aworldlaser 14w RGB Scanner DT50w 80 degrés

2 laser Aworldlaser 20w RGB scanner DT40 60 degrés

1 laser Aworldlaser 32w RGB Scanner DT50B 60 degrés

4 laser Aworldlaser 35w RGB Scanner DT50B 60 degrés

1 laser Aworldlaser 45w RGB scanner DT50C 60 degrés
Location: LYON
Contact:
Contact philippe69

Phoenix Micronet slim + switch rj45 trouble

Post by philippe69 » Mon 25 May, 2015 11:18 am

hello I have trouble with a configuration 4 Phoenix Micronet slim
switch on the network that I exceeded 25m cable
phoenix recognize in the hardware list, but the laser does not work
programme of the screen freezes I require to reboot the pc

use a small switch hub D-link I think it is not suitable for this type of installation

I Noticed the problem During a performance with 5 laser

2 laser green with 2x 50m cables

3 that function
If I disconnect the 2 laser 50m cables on the switch
is after a reboot of the PC 3 other rgb laser works with 25m cable

someone has faced this kind of problem
which switch you use ?
Facebook Philippe Aworldlaser
Top
Post Reply

Return to “Installation von PHOENIX”

Who is online

Users browsing this forum: No registered users and 2 guests