dead dream lasers

[djwacko]

hi, i have a 35mW dpss module from "dream lasers" but, not knowing that there was a positive voltage on the housing of the lasermodule, i connected the module to am metal housing an gone was the output. in an attempt to repair the unit, i messured + 2V and 0.5A and if i look into the diode ( i know it is not safe) then i see a small dim red laser light burnig. can some one tell me what to do. is there eneyone who has experience with these units?

[doctoritchy]

hello

if you have a laser diode pumping is burnig but not lase

this diode pumping is out , whitch not 808nm but 790nm is decaled frequençy !


sorry my english is bad , you speaking french ?

[djwacko]

sorry, i don't speak french.
only dutch and english

do you have any idea what i can do abaud it?

thanx for your response

[tracky]

Hi, you need a new 808nm laser diode. This unit is not isolated! When the DPSS mounted on a basis plate you have full 5 volts on the housing! Danger! Short with ground! This laser diode is 100% destroyed!

[djwacko]

dammmm, i hoped sins there was still red light emmitting, that the diode was still ok.