Hi Heiko,

First: you must connect pin 16 ( "minus" Intens/Blanking ) to pin 25 "GROUND" )
After this you will have on pin 3 ( "plus" Intens/Blanking ) analog signal from 0 to +5V. This signal you can send directly to TTL input of DPSS laser, and usually it work without problems.
More right solution ...

Hi Gento,

Write please, you talk about "8-bytes structure of point" or about "8-bit resolution on X&Y DACs"?

It absolute diferent concepts!

Ihor

Hallo Björn,

Please write description (technical specification) of inputs your PCAOM, and I will write you full information about connection.

All the best
Ihor Ralko
RIYA Co

Hi,
AlexS is absolute right: when you will used power supply from PC, you must used "rail-to-rail" OP AMP.

Unfortunately, A&A not support ILDA Standard (5 V) (or ILDA not support A&A :-)))

We have decided this problem in our new version of cards: we have installed in card four switches for 5 ...

Hi Simon,
FPGA, in difference to microprocessors, allows to organize realy multitasking work.
We don't use FIFO and DMA.
Two buffers RAM (one - for load information, second - for out on DACs) allows us in Target mode to provide up to 200 000 PPS with quaranted accuracy 30 nsec.

Ihor

@John,
In RIYA card we use FPGA (not Coldfire)

Ihor

I agree, it was not a correct phrase.
It was the proposal on lasers, which were manufactured in Ukraine earlier .
I have corrected already ...

Ihor

Hallo Bernd,
If you want to use DMX, please pay attention on our card RIYA PCI Pro in www.riyalasers.com
In this card are installed two DMX output and one DMX input channels (all independent, with galvanic isolation)
We present with our cards SDK and drivers for Windows98/2K/NT/XP

Also look ...