www.LaserFreak.net

I solved the problem it was a ic, but the next problem and hopefully the last one, ik bought a laser http://www.dealextreme.com/p/100mw-650nm-red-35mw-532nm-green-laser-module-12v-46394 with a TTL blanking port, can i connect this to the blanking port on the bILDA? and how do i know wich wire goes ...

My bILDA doesn't work anymore, but if i meassure tthe output, pin 1 and 2 are now - and 14 and 15 is +, that is wrong, some one any idea what is broken on my board?

I get a outlined square, like the biggest it can get, but with no ground i mean, that it has no earthing (masse), but if you look at picture on top, you can see a Z, but in peaces each corner got a piece.

The galvo's that i used are http://cgi.ebay.nl/20Kpps-laser-scanning-galvo-scanners-ILDA-/190474938095?pt=LH_DefaultDomain_0&hash=item2c5930e6ef#ht_1076wt_1139 ,
it must look like a outlined "Z". The voltage going in the bILDA is +12,47 and -12,03. The wall outled has no ground. The scanning speed i ...

Sorry, i fixed the hotlink protection.

Next problem, i bought galvo's but i can't get a good picture out of it, some times when the bilda is a time on it displays my picture but al the other times it looks like:


Anyone a idea what is going wrong?

Mine steppers still don't move, but what voltage does the output from the bILDA have, when i draw a line it gives only 0.43V and -0.43V. Can anyone meassure his output? I'm getting irritated about it...

Wich version did support bilda? and with witch driver?

With He-laserscan ML_driver do i need for the linux-laser.org DAC? I tried them al, and could'nt find any hardware devices

Thank you, now i want tot test my print, is it possible to connect mots1 motor, and how do i do that? For the properties of the mots1 : http://store.qkits.com/moreinfo.cfm/MOTS1

If i try to find new hardware, and select the .inf, the computer doesn't find any drivers for hardware, i am going crazy. And if i plug the usb in my computer the board is being installed as a unknown usb device, and can't update the driver to an other, is that right? Because popelscan doesn't see ...

I have the problem, if i try to install the bilda drivers, my computer crashes, so does my other computer, any one knows what i do wrong, it is a windows XP system with service pack 3, my bilda is still without a programmed Eeprom.