www.LaserFreak.net

Hi Flo,

Thanks for the quick reply!
Time to go to the eletronic-parts store.

Abondi

Hi all,

I just bought a set of M9024 second handed, but the power supply part is missing on the circuitboard.
Could someone specify the values for C1,2 C5 R60 and most of all which trafo to use? Primary it is 2*115V but how much should the secondary side be? 2*12V or 2*15V and how many VA is it ...

Analoog en ttl blanking is wanneer je de laser electronisch gaat blanken,
je zou ook nog voor een mechanische blanking kunnen kiezen dmv een galvo/stappenmotor (mot1).

Hi Tobias,

I know that you cannot drive the laser directly from the balanced output of the DAC. I would use a similar circuit as described in this post. http://www.laserfreak.net/forum/viewtopic.php?t=38633
I am sure I did not make a measurement fault. I will write an e-mail to Lasever to ask if ...

Sorry that I have to write in English, I can read German but writing.... :(

I bought an 300mW green Lasever two weeks ago and did some tests with it, to "modulate" it I just used my bench PSU.
With full output at 5V the laser draws 53mA! My question is wich DAC do you use which can supply this ...