Page 1 of 1

Beam Switch Shutter

Posted: Sun 23 May, 2010 11:35 am
by housedeejay
Hi, sorry for writnig here but I was at English laserfreak and it seems that nobody is active there... :?

I want to build simple Laser Bank...I think about 3 - 5 effects.
So I need beam switches...and those would be controlled from Popelscan with "D - Latches"

Is it possible to build these beam switches ? :wink:

Re: Beam Switch Shutter

Posted: Sun 23 May, 2010 12:20 pm
by lightwave
Hello,

you can use beamswitches like "medialas STP8", which have a wide range of signal input voltage (4 to 20V is possible). You can also find older versions e.g. on eBay,... which work with 5V Input.

Or you make a DIY-project as like as MOT-1 steppers...

Re: Beam Switch Shutter

Posted: Sun 23 May, 2010 2:37 pm
by housedeejay
I will try to build DIY switches... ;)

http://www.eleccircuit.com/wp-content/u ... n74194.GIF

Is it possible to make this driver work with Poplescan DAC ?