www.LaserFreak.net

Hi All

Could someone help me with following problem:
I've bought a Laserworld CS-400rgb laser controlled by Phoenix live.
Drawing goes perfectly, but the image is off center.
I made adjustments in Phoenix live but the image dissapears before reaching the centre.
No loose cables have been found, disconnecting x- and y- didn't solve the problem.

Thanks

hi ! and welcome...

Are you sure that the spot is right in the middle of the scanner mirrors ? you can look at that first .

Hi

If I use the laser in dmx mode the graphics are perfectly centered in front.
Once I start sending ILDA the output jumps to the right, it's like an offset is being added.

Thank you

Raph