www.LaserFreak.net

Hello,

i have a easylase usb controller but the device has no dmx connectors or tll connector in the case

Does some one have a easylase usb controller with those connectors? if so is it possible to make some pictures of it so i can build the connectors on in

thanks..

Download the .zip file with the documentation and drivers here

Inside the .zip is the schematic for the DMX part...

Hope this helps...

thank you, now i know the layout the only problem left is that i don't understand the 2 symbols (max485cpa) are those ic's ? or is it possible to connect those dmx connectors directly to the board?

cyplex hat geschrieben:thank you, now i know the layout the only problem left is that i don't understand the 2 symbols (max485cpa) are those ic's ? or is it possible to connect those dmx connectors directly to the board?

These are ICs.
But I think you should buy the addon-board or let somebody else build the addon board for you
If you don't know exactly how to do, you can damage the whole thing.

Joachim

yes i think this is the better solution if you not know the electronic
the max485 are RS485 bipolar drivers/receivers

the IC create symetrical signal for DMX standrat and preamplifer for long distançe

well now do know what the symbols are now i could build it normaly i don't build electronics on this way i use always a diverent layout and symbols.

Does any one have a id what the add on board cost?

i live in the netherlands.