Page 1 of 1
schema for laserdrive 9600 serie
Posted: Wed 15 Feb, 2006 4:38 pm
by doctoritchy
hello all
i am many problems whit my power supply
the current regulation is not good , my power supply block at 12A !!!
i am searching schematics for the laserdrive 9600 serie power supply
if you have !!
thank's for all
( and sorry for my bad english ! )
Posted: Wed 15 Feb, 2006 5:58 pm
by heidi
Hi,
Output-Discharge Ionized
- 70 to 110 Volts DC
- 3.5 to 12 Amps DC - Adjustable in Current Control Mode or
- 0 to 20 milliWatts - Adjustable in Light Control Mode (12 Amps internal limit)
So did you know, if it would supply more than 12 Amps?
Are there enought reserves?
For what kinde of Head? normal small air-cooled Argon Laser did not want such high Amps, if you want to keep it alive.
Heidi
Posted: Wed 15 Feb, 2006 6:13 pm
by doctoritchy
hi
i am already manual of power supply , but i am searching internal schematics !
this probleme is not regulation fonctionally !
this laser run at 12Amp constant the level pot trim has not changed the power output ( power supply in current mode )
my laser head is ALC60X head ( whit laserdrive 150V trigger )
only problem is not level power adjut , only 12amp at 130V !!!!!!
Posted: Wed 15 Feb, 2006 9:33 pm
by lightfreak
Maybe theres a defect in the passbank of your supply. If there is one or more transistors defect, the current regulation won't work.
Maybe a driver transistor is defect, so the passbank could not decrease the current.
Simon
Posted: Wed 15 Feb, 2006 9:59 pm
by doctoritchy
hmm yes , but
the pass bank is ok !
on the boot of power suplly , voltage in the tube up 0 to 150V slowy , and input passe bank are 300V DC rms!!
is the problem has my opinion in the controller part or perhaps upstream thing bizzard the detection part and the puissançe part is isolee with a optocoupler and has same optocoupler I have itself either 1.6V or 1.4V according to the position of the potentiometer? but I am not on nothing! it is so that I would like to have the diagram!
(sorry for my bad english !)
Posted: Thu 16 Feb, 2006 10:37 am
by doctoritchy
link to my french post and the photo power supply models !
viewtopic.php?t=37635
Posted: Thu 16 Feb, 2006 8:56 pm
by starburst
Mein I70 ist vor einem halben Jahr dank des Italienischen Klimagerätes eingegangen. Hast du Daten für deinen Kopfß Leistung bei RGB...
Meiner hatte 8 Watt Weißlicht und satte 2,2 Watt Rot! Ein Mördergeiles Teil war das. *heul*
Posted: Thu 16 Feb, 2006 10:22 pm
by doctoritchy
sorry I dont uderstand german !
Posted: Wed 22 Feb, 2006 9:26 pm
by doctoritchy
Hi,
would somebody have it it is famous schematics ?
thank's
Posted: Wed 05 Jul, 2006 11:05 pm
by doctoritchy
hello all
my power supply is good , the curent regulation is ready , simply aop 4741cp and 2 1n4841 diode and 2 2n9806 transistor to change !
good day