Gebbi wrote:Hi.
Ich suche für ein Projekt an der Uni Daten zu diesen beiden Scannern.
Sind in einem alten Beschriftungskopf eingebaut. Dummerweise sind die Originalstecker nicht mehr dran.
Hat vielleicht jemand die Kabelbelegung dafür? Würde mir schon einiges weiter helfen.
Danke schonmal,
Ciao, Gebbi
G100PD wiring
There are two cables connected to the galvo, one is the galvo coil cable and the other is the position sensor cable.
Position sensor cable
Wire Colour Signal/Function Description
Orange Position Sensor - Ground or common
Black Position Sensor - Negative output signal
Red Position Sensor - Positive output signal
White Position Sensor - Supply (+12 VDC)
Brown Position Sensor - AGC (normally grounded)
Additional wires may be present on the G100PDT for the heater blanket and Thermistor (see note 3 below).
Drive coil cable
Wire Colour Signal/Function Description
Red Coil 1 - High (See notes 1 & 2)
Green Coil 1 - Low (See notes 1 & 2)
Yellow Coil 2 - High (See notes 1 & 2)
Black Coil 2 - Low (See notes 1 & 2)
NOTES
1/ To wire drive coils in series, connect Black to Green and drive Red to Yellow. Series wiring is recommended for use in position sensing (closed loop) mode.
2/ To wire drive coils in parallel, connect Red to Green and Black to Yellow. Use parallel wiring only when driving the galvo in open-loop mode.
3/ Heater blankets are mounted only on the G100DT type galvos and are not commonly used in light show applications.
