Page 1 of 1

Blanking Pins bei Qm2000

Posted: Thu 01 Jul, 2004 9:19 pm
by tom83
hallo arbeite erst seit kurzem mit Pangolin und schraube gerade ein eine bank zusammen die anschlüße für das scanning sind mir bekannt aber auf welchem pin hab ich einen 0-5V ausgang für ttl blanking

mfg tom

Posted: Thu 01 Jul, 2004 10:15 pm
by thomas
Hallo Tom,

Pin 3 Intensity/Blanking + (0 bis +2,5V), Pin 16 Intensity/Blanking - (0 bis -2,5V).
Pin 16 stellt dabei die TTL-Masse dar.

http://www.pangolin.com/LD2000/qm2000pinouts.htm

Gruß Thomas.

Posted: Thu 01 Jul, 2004 10:36 pm
by bernd
Aber ACHTUNG:

Dabei muß deine Diode / DPSS oder was auch immer Erd-/Massefrei montiert sein und auch die Stromversorgung dafür muß Erd-/Massefrei sein!

Lies dir mal den Thread viewtopic.php?p=39793&highlight=#39793 durch - da ist auch ein Schaltplan drinn.

Grüße Bernd

Posted: Tue 06 Jul, 2004 9:16 am
by pangolinlaser
Hello all,

There is one extraordinarily important point here, but a point which people seem to constantly miss...

Yes, the Intensity signals can be found on pin 3 and pin 16, and yes, pin 3 in Intensity+ and pin 16 is Intensity-. BUT!!! The voltage levels can only be observed ACROSS THESE TWO PINS!!! This means that when observing the signal, you must connect your scope or laser (not a meter!!) between pins 3 and pin 16 to get an accurate reading. You can NOT!!! connect your scope between ground and pin 3 and get an accurate reading. You may observe 0 to +2.5V on pin 3, or you may observe between 0 and 5V, or you may observe between 5V and 10V for that matter. All of which are legal and possible, because pin 16 will be "complementing" pin 3 in such a way to give a total voltage range of 0 to 5V.

HOWEVER!! In 99.9994 percent of the cases, Pangolin STRONGLY recommends that you connect the negative color outputs, directly to ground, thus giving you all output from the positive output (in this case, pin 3).

More information about color signals, use with PCAOMs, etc. can be seen at the topic:
viewtopic.php?t=35554&start=0

Best regards,

William Benner

PS: Sorry for all the CAPS and !!! but this is a sort of sour topic with me. I find myself explaining color and signal levels so many times, over and over. Maybe I will write a book about this topic some day...

Posted: Tue 06 Jul, 2004 4:58 pm
by bernd
Hallo,

klar - muß mich korrigieren was die QM2000 angeht...

Nach Pinbeschreibung können die - (Minus) von den Farbkanälen und Blanking problemlos auf Masse gelegt werden.

Bernd

Posted: Tue 06 Jul, 2004 6:26 pm
by richi
Hi,

nachdem das Thema immer wieder auftaucht und teilweise echt abenteuerliche Ergebnisse dabei rauskommen habe ich mal eine Anleitung erstellt wie was angeschlossen wird.

Sollte hier noch ein Fehlerteufel drin sein oder etwas fehlen dann einfach melden.

Hier ist sie zu finden:
http://www.laserstar.de/anleitung_symet ... trisch.pdf