Pour la figure j'enregistre le fichier ilda et je le met dans quickshow je suppose....
Sinon Richard vient de m'envoyer sa en anglais(Je capte un peu l'anglais et google traduction m'aide un peu au pire mais je ne comprend pas la marche a suivre exactement...si quelqu un peut m'expliquer un peu plus simplement la marche a suivre sa serait sympa..
...En attendant je vais tester avec la figure que tu m'as indiquée Olive..):
Voici les potentiomètres : (au fait Damping c'est quoi c est le PR5?
)
PR1: Gain
PR2: Size
PR3: HF
PR4: LF
PR5: Offset
setting up completely deadjusted drivers
when a driver is completely deadjusted, the scanners can oscillate after power on.
switch-off the driver immediately.
adjust size and gain counterclockwise, until the endposition of the potentiometer is reached.(hearable clicks)
apply a zero input signal to the driver inputs.
switch on the driver.
when a frequency or oscillation is hearable,turn damping counterclockwise, until the frequency disappears.
use a simple tesframe input,for example a square with slow speed(2 kpps)
Increase the size slightly by turning size clockwise.
do not adjust to maximum scan size!
increase gain by turning gain clockwise.make sure that overshoots do not exceed maximum scan angle.
reduce overshoots by truning damping clockwise.
repeat increasing gain and damping until the image looks best.
adjust size at maximum signal to desired image size.